Atheronix.

Home › Appliances

How much does an immersion heater cost to run?

An immersion heater is an electric element inside a hot water cylinder, typically rated at 3,000 W (3 kW). It runs until the water reaches the thermostat setting. The energy needed depends on how much water you heat and how much it warms up.

At full power, a 3 kW immersion heater costs about 79p an hour (3 kWh × 26.32p/kWh).

Typical running costs

Example usekWh/dayPer dayPer monthPer year
1 hour a day 3 79p £24.02 £288.20
2 hours a day 6 £1.58 £48.03 £576.41
3 hours a day 9 £2.37 £72.05 £864.61

Based on 3,000 W (CSE average rating) and 26.32p/kWh, the Ofgem price cap average Direct Debit unit rate for 1 October – 31 December 2026. Usage patterns are examples. Standing charges are excluded.

Calculate your immersion heater cost

Per day–
Per week–
Per month–
Per year–
Energy per day–

Starts at 26.32p/kWh, the Ofgem price cap average Direct Debit unit rate for 1 October – 31 December 2026. Use the unit rate on your own bill for a better estimate. Standing charges are not included.

Heating a full cylinder

Heating 150 litres of water from 15 °C to 60 °C needs about 7.9 kWh (150 kg × 4.19 kJ per kg per °C × 45 °C), which costs about £2.08 at the current reference rate. At 3 kW that takes roughly two and a half hours. If the water is only partly cold, it takes less.

Do not leave it on all the time

With a thermostat the element switches off once the water is hot, but a cylinder still loses heat through its walls and pipes, and the heater keeps topping it up. A timer that heats water shortly before you need it, and a well-insulated cylinder jacket, reduce that loss.

On an Economy 7 or similar time-of-use tariff, heating water overnight at the cheaper rate can cost much less. Enter your night rate in the calculator.

Thermostat and safety

Stored hot water should be heated to at least 60 °C, which controls Legionella bacteria, so turning the cylinder thermostat down a long way is not a safe way to save money. Savings come from heating only when you need hot water, and from insulation.

Immersion heaters are hard-wired, so measure one with your smart meter display: note the kWh total when it switches on and again when the thermostat switches it off, with other large appliances off.

Questions

How long should I leave the immersion heater on?

Long enough to heat the water you need. For a full 150-litre cylinder from cold, around two and a half hours at 3 kW; for topping up, less.

Is it cheaper to heat water with gas or an immersion heater?

Usually gas, because electricity costs several times more per kWh under the current price cap. An immersion heater on a cheaper night-time rate narrows the gap.

Related

Sources